Analysis of Plastic Deformation of the Cut Layer

elastic and plastic deformation shrinkage of chips heat generation build-up work hardening tool wear

Authors

  • Asatillaev Yuldashali Malikovich
    Asatillaev@gmail.co
    Associate Professor, Ph.D., Namangan Engineering Construction Institute Republic of Uzbekistan, Namanagan city, 12 Islam Karimov street
Vol. 1 No. 5 (2021): October
Articles
October 18, 2021

Downloads

The article discusses cutting metals using a cutting tool under a complex physical process. The elastic - stressed state and deformations of the surface layer of the workpiece in the cutting zone are analyzed. The graphs and conclusions from the results obtained are presented.

Similar Articles

1 2 3 4 5 6 7 > >> 

You may also start an advanced similarity search for this article.